Search results for " Mössbauer"
showing 10 items of 26 documents
High-performance Mössbauer spectroscopy: Criteria, possibilities, limitations
1992
Increasing attention is being paid to non-conventional Mossbauer methods in view of the extension of Mossbauer Spectroscopy (MS) to a broadening field of applications. With such long-lasting experiments the shortening of the measuring time required for a given statistical significance is of major practical importance. It is shown that the statistical utility rateu allows one to determine which experimental parameters have a primary role, and it also enables sucessive optimization. It is pointed out for various MS measurements that the strategy for improving the experimental performance is strongly dependent on the given problem. As examples, time-differential Mossbauer measurements and conv…
Conversion electron Mössbauer study of low carbon steel polarized in aqueous sulfate and sulfite containing sulfate solutions
1993
Abstract The passivation of low carbon steel was studied in aqueous solutions of 0.5 M Na 2 SO 4 (pH = 3.5 and 6.5) and of 0.5 M Na 2 SO 4 + 0.001 M NaHSO 3 (pH 3.5 and 6.5). The used conversion electron Mossbauer spectroscopy (CEMS) with the complementary electrochemical, microscopic and spectrophotometric investigations proved that the presence of sulfite ion induces pitting corrosion. The compositions and thichnesses of the passive films formed during the electrochemical treatments are determined from the conversion electron Mossbauer spectra. γ-FeOOH was found in each case as a major component. At pH = 3.5, the sextet belonging to Fe 3 C appears in the spectra in most cases, and also Fe…
A corrosion study of austenitic and martensitic steels under boiler conditions by means of 57Fe conversion electron mössbauer spectroscopy
1978
Abstract The growth of protective oxide layers on a martensitic FeCr (1.4122) and two austenitic FeCrNi steel samples (1.4550 and Incoloy 800) was studied by means of the 57Fe Conversion Electron Mossbauer Spectroscopy (CEMS). Scanning electron microscopy was applied to characterize the topographical nature of the oxide layers. Following a technical procedure of running-in steam generators, the steel specimens were oxidized in oxygen-free water at 295°C, 142 bar and a pH value between 9 and 10 for periods up to 70 h. In the case of the steels 1.4122 and 1.4550 the only oxide phase detected was non-stoichiometric magnetite, whereas nickel ferrite of nonstoichiometric composition was found…
Problems of electron detection in Depth-Selective Conversion Electron Mössbauer Spectroscopy
1992
Applications of Depth-Selective Conversion Electron Mossbauer Spectroscopy (DCEMS) are limited by the long measuring times needed for collecting sufficient data statistics. To shorten the recording time, the background should be reduced and the detection efficiency for conversion electrons should be improved. For57Co/57Fe DCEMS, systematic studies were performed to investigate the origin, shape, and structure of the background components in DCEMS data distributions for various samples using channeltrons and low-noise scintillation counters as electron detectors.
Synthesis, characterization, crystal structures and in vitro antistaphylococcal activity of organotin(IV) derivatives with 5,7-disubstituted-1,2,4-tr…
2011
Abstract New organotin(IV) complexes of 5,7-ditertbutyl-1,2,4-triazolo[1,5-a]pyrimidine ( dbtp ) and 5,7-diphenyl-1,2,4-triazolo[1,5-a]pyrimidine ( dptp ) with 1:1 and/or 1:2 stoichiometry were synthesized and investigated by X-ray diffraction, FT-IR and 119 Sn Mossbauer in the solid state and by 1 H and 13 C NMR spectroscopy, in solution. Moreover, the crystal and molecular structures of Et 2 SnCl 2 (dbtp) 2 and Ph 2 SnCl 2 (EtOH) 2 (dptp) 2 are reported. The complexes contain hexacoordinated tin atoms: in Et 2 SnCl 2 (dbtp) 2 two 5,7-ditertbutyl-1,2,4-triazolo[1,5-a]pyrimidine molecules coordinate classically the tin atom through N(3) atom and the coordination around the tin atom shows a …
Study of Fe−Ti and Fe−TiN interfaces by conversion electron Mössbauer spectroscopy
1992
Titanium and titanium nitride-iron interfaces obtained by PVD coated thin films of Ti and TiN onto argon plasma etched iron substrates at various temperatures and negative bias were studied by use of CEMS. It was found that intermixing to Ti with Fe resulted in the appearance of an amorphous FeTi1−x phase. Furthermore, a comparison of CEM spectra of samples before and after heating in UHV has shown rather strong influence of thermal treatments on Fe/Ti as well as Fe/TiN interfaces.
Ferromagnetic ordering in GdPdCd
2010
Abstract GdPdCd was obtained in pure form via reaction of the elements in a sealed tantalum tube in a high-frequency furnace. The structure was investigated by X-ray diffraction on both powders and single crystals: ZrNiAl type, P 6 2m , a=758.2(1), c=391.78(7) pm, wR2=0.0410 for 358 F2 values and 14 variables. Striking structural motifs of GdPdCd are two types of palladium-centered tricapped trigonal prisms [Pd1Cd3Gd6] and [Pd2Cd6Gd3]. Together the palladium and cadmium atoms build a three-dimensional network in which the gadolinium atoms fill distorted pentagonal channels. Susceptibility measurements reveal Curie–Weiss behaviour with an effective magnetic moment of 8.2(1) μB/Gd. GdPdCd ord…
Diorganotin(IV) N-acetyl-L-cysteinate complexes: synthesis, solid state, solution phase, DFT and biological investigations.
2009
Diorganotin(IV) complexes of N-acetyl-L-cysteine (H(2)NAC; (R)-2-acetamido-3-sulfanylpropanoic acid) have been synthesized and their solid and solution-phase structural configurations investigated by FTIR, Mössbauer, (1)H, (13)C and (119)Sn NMR spectroscopy. FTIR results suggested that in R(2)Sn(IV)NAC (R = Me, Bu, Ph) complexes NAC(2-) behaves as dianionic tridentate ligand coordinating the tin(IV) atom, through ester-type carboxylate, acetate carbonyl oxygen atom and the deprotonated thiolate group. From (119)Sn Mössbauer spectroscopy it could be inferred that the tin atom is pentacoordinated, with equatorial R(2)Sn(IV) trigonal bipyramidal configuration. In DMSO-d(6) solution, NMR spectr…
Surface spectroscopic study of the corrosion of ultrathin57Fe-evaporated and Langmuir-Blodgett films in humid SO2 environments
2000
Integral conversion electron Mossbauer spectroscopy (ICEMS), x-ray photoelectron spectroscopy (XPS), Auger electron spectroscopy (AES) and scanning electron microscopy (SEM) have been used to carry out a comparative study of the corrosion resistance against humid SO2-aggressive environments of ultrathin 57Fe films. These films, having a thickness ≤ 2.5 nm, have been prepared by evaporation of 57Fe under vacuum and by 57Fe coating by a Langmuir–Blodgett (LB) technique on SiO2/Si wafers. The results have shown that the corrosion resistance of the evaporated films is similar to that of massive Fe. However, the LB films show a remarkably higher corrosion resistance. Thus, although the Fe films …
Observation of substitutional Fe in CEMS measurements on synthetic CVD diamond
2004
Conversion electron Mossbauer spectroscopy measurements have been made on a diamond sample synthesized by chemical vapour deposition. The sample was implanted with 70 keV 57Fe to a dose of 5 × 1014 cm−2 and Mossbauer measurements were made on the as-implanted sample and after annealing at temperatures of 600 K, 950 K and 1470 K. The spectra at the lower temperatures were characterized by broad doublets, but the annealing at 1470 K resulted in dramatic decrease in the intensity of the doublet components, and the appearance of a strong single line with an isomer shift of δ = −0.90(5) mm/s and areal intensity of 30%, and a weaker line (5%) with δ = +0.07(4). Arguments are presented to attribut…